THIS KIT INCLUDES A PREMIUM QUALITY FUSER SLEEVE AND GREASE TO REPAIR YOUR HP LASERJET 1160 / 1320.

 

SYMPTOMS OF A BAD FUSER FILM SLEEVE IS IT HAS BEGUN TO GIVE YOU SMEARED PRINTS DUE TO DAMAGE TO THE FUSER SLEEVE OR YOU SEE TEFLON FLAKING OFF ONTO THE PAPER AND HEARING A PAPER CRUNCHING NOISE WHEN PAPER RUNS THROUGH THE FUSER.

 

WHEN YOU SEE SUPER CHEAP SLEEVES PLEASE REALIZE THAT THIS IS A PART YOU DO NOT WANT TO BUY INFERIOR PRODUCTS FOR. THE AMOUNT OF WORK TO REPLACE A SLEEVE IS CONSIDERABLE, DON'T FIND YOURSELF IN 1000 PAGES BACK IN THERE WITH ANOTHER TEAR.

 

YOU WILL BE IMPRESSED WITH THE FINISH AND QUALITY OF THE SLEEVES I SELL. I WILL NOT SELL JUNK LIKE OTHER VENDORS DO. THIS KIT DOES NOT HAVE DIRECTIONS. AGAIN, THIS HAS NO DIRECTIONS,

 

THERE IS NO SUPPORT ON THIS PART.

 

FIGURE A REBUILT 30DAY WARRANTY FUSER IS 150-190 DOLLARS + SHIPPING + RETURNING THE BAD FUSER. SO FIGURE 150-200 DOLLARS. NOW CONSIDER SPENDING 1 HOUR YOURSELF AND FOR A FRACTION OF THE COST, DOING THE REBUILD YOURSELF. IF YOU HAVE CONCERN OF "IS IT REALLY A BAD FUSER?",

 

DO A 1/2 PAGE TEST. PRINT A TEST PAGE AND WHEN THE PRINTER IS PULLING THE PAPER IN BUT BEFORE IT GETS INTO THE FUSER, TURN OFF THE PRINTER. OPEN UP THE CARTRIDGE DOOR, REMOVE THE CARTRIDGE AND INSPECT THE PRINT. IF THE PRINT LOOKS CLEAN AND GOOD, THEN THE FUSER HAS THE PROBLEMS. TO CHECK THE SLEEVE, OPEN THE REAR DOOR AND LOOK AT THE GRAY SLEEVE - LOOKS LIKE A ROLLER AND IF YOU SEE ANY CUTS, TEARS OR TONER BUILDUP ON THE GRAY SLEEVE IT NEEDS TO BE REPLACED.

 

THE FUSER USUALLY GETS DAMAGED FROM IMPROPER PRINTED ITEMS (TRANSPARENCIES), OR LABELS. THE SLEEVE IS THE MOST COMMON ISSUE BUT THERE IS A SMALL CHANCE THE ROLLER UNDER THE SLEEVE (ORANGE COLOR) CAN ALSO GET DAMAGED IF SOMEONE WAS STICKING SHARP OBJECTS INTO THE PRINTER TO CLEAR A JAM.

 

THIS KIT INCLUDES THE FOLLOWING:

PREMIUM TEFLON FUSER SLEEVE 

TEFLON SLEEVE GREASE (SMALL BAG NOT SHOWN)

 

THESE PARTS COME WITH A 30 DAY VERIFY ITEMS ARE SHIPPED AND IN PROPER CONDITION. ONCE YOU INSTALL THE PARTS, THE KIT CANNOT BE RETURNED. PLEASE CHECK THE BOX AND THE SLEEVE AND ROLLER UPON RECEIPT FOR ANY SIGNS OF SHIPPING DAMAGE AND I WILL ACCEPT THE RETURN AND SHIP YOU A NEW KIT. AFTER YOU USE THE PARTS, THE KIT IS NON RETURNABLE FOR REFUND OR EXCHANGE.